| |
|
Exhaust Tunnels
Between road spray and heat stress, these pieces have a tough fight to survive. We can make replacements for damaged ones, or new pieces to accommodate modified exhaust paths. |
|
|
 |
Tiger Exhaust Pass-Thru
... under construction | | |
 |
Custom Exhaust Pass-Thrus
[F17] | | |
 |
Custom Front Frame Components fabricated for a Tiger.
[F8] | | |
|
Floor Pans
We manufacture, distribute and install the best floor pans available for the Marque. |
|
|
 |
Tiger Set
From below, with inner rocker sections and seat supports [F1] [F13] | | |
 |
Rear Passenger Floor with Seat Frames
The black II is a frame for locating the seat exactly across the two rails. | | |
 |
Rear Parcel Shelf
The fitting stage is crucial, especially for a wide flat piece like this shelf: measure twice, cut once, then fix firmly in place. | | |
 |
Fitting Tiger Floor Set
The frame is locked in place with reinforcements to maintain an accurate fit. | | |
Tiger Floor Set: Installed
This car was previously rusted from "the shins down." Floors and frame components were fabricated and carefully fit. | |
|
|
| |
|
Lower Fenders
Salt-spray from below, wet carpet above, and eventually the whole lower fender isn't strong enough to support the floor nor any outer metal. Notice the multi-part structure of the inner fender. |
|
|
|
|
|
| |
|
Transmission Tunnels
Some of the toughest fabrication work may be needed right under your nose (and over to the left or right a bit). This Tiger tunnel is a complex piece of reproduction work that has to maintain both cosmetic and structural integrity. |
 |
Before the Magic
"Where to start?"
This is a complex 3-D piece. | | |
 |
During Welding
The different planes of the piece are fabricated separately and then butt-welded to create a new whole. | | |
 |
Ta-Da!
Who would have thought? [T4] | | |
|
